Type: Posts; User: breeze400
I marked the holes on the outside of the hull using the flashlight method. Then heated the point of a ice pick, anything with a point on it will do, on the stove. Just touch the hull where you have...
When your going at a slow pace you won't see much water coming out. But running at speed you will. Are you sure this isn't the case here?
Not sure if you can. Did you try castle?
I had the red green beeping thing going on too last week. I found out one of my batteries was overcharged. It was reading 13.58 volts. I changed that set of batts out with my other set and worked...
Thanks guys! I greese up my cable after every day of running. I only have 2 sets of lipos so my run times only bout 1/2 hour with my stock bats in there too.
Hi you all. I was doing some maintanence on my spartan yesterday. I came across this issue while putting her back together. First I noteist that the vinel Liner was loose in the tube.then when I spun...
I had the go pro mounted on my boat but for some reason it did not take any video! Hmmm probublly the operator! Lol
Yes good luck! Let us know how you make out!
Hi you all! Had my boat out on the niagra river Sunday. It was too rough! Flipped over, sunk! Oh well. Dryed everything out no problems. Luckily I greesed up the wires coming out of the RX. No water...
Cool!! I'd like to see her at night!
Did you have your esc set to lipos? If not you may have over drawn them.
Isn't there a castle rep some where over there? I would call them and ask what the heck is this? That's not right! All you should have to do is plug everything in and go!
Don't know the measurements exhackly! The holes are allready there in the iner hull. All you have to do is take a bright flashlight and shine it through the hull from the inside out. Dim the outside...
They got wet! That's how. Lol. When you sink a boat that bad you have to take it all apart and dry everything!
PS rx and servo connected to power through the esc! Water power short puff the...
You should just keep it for a spare!
That's what I thought too. I got an e mail from them earlier. I like the four tab set up with adjusters!
The tabs should be adjusted 1mm below the hull to start with then adjust has needed from there.
Thanks, orca44! I remember seeing that Sean on you tube before! Lol
That's only possible on the weekends. I drive for a living so I'm gone all week long. Lol
I'm on my I pad!
You need the 6s set up to get above 50!
If there's a link there I don't see it!
I don't know about thet since I went from stock waterlines to bigger ones you can noticeably see much more water coming out the outlet.
I think you might be looking so a few pics of people using a black gromit or o ring to seal the flex shaft between the hull and the drive strut!
I use fittings on mine. But you can just drill a tight hole for the line. You will know what I mean when you get your boat and pull the stock line! Lol. I bought thru hull fittings at my LHS for...