Search:

Type: Posts; User: BAD RC

Page 1 of 14 1 2 3 4

Search: Search took 0.01 seconds.

  1. Thread: Going straight.

    by BAD RC
    Replies
    12
    Views
    391

    Check your servo saver for looseness. Realign...

    Check your servo saver for looseness. Realign your servo. See video.

    http://www.youtube.com/watch?v=b8Tvn6cHYFQ
  2. Thread: Vxl3

    by BAD RC
    Replies
    4
    Views
    162

    Check for binding/drag on the drivetrain. You may...

    Check for binding/drag on the drivetrain. You may have a bearing seized.

    Message sent from MARS via CURIOSITY.
  3. Replies
    3
    Views
    324

    1.5 2.0 mm Message sent from MARS via...

    1.5 2.0 mm

    Message sent from MARS via CURIOSITY.
  4. Replies
    7
    Views
    453

    May need to cut a slot and remove the screw with...

    May need to cut a slot and remove the screw with a flat head screwdriver.

    Message sent from MARS via CURIOSITY.
  5. Replies
    63
    Views
    5,134

    Same here. I shared it with a few non-rc friends,...

    Same here. I shared it with a few non-rc friends, and they can't seem to get over the speed ...and the crash.
  6. Replies
    26
    Views
    388

    I don't run the Traxxas nitro fuel in my 3.3. I...

    I don't run the Traxxas nitro fuel in my 3.3. I have had really good experience with Bryans Fuel. Easy start, cooler temps and tuning stays constant. I ran the Traxxas Nitro fuel at first. Lots of...
  7. Replies
    6
    Views
    212

    Loosen up your Servo Saver, could be too tight. ...

    Loosen up your Servo Saver, could be too tight.

    Sent from Mars Curiosity.
  8. Replies
    63
    Views
    5,134

    Pretty close to running into you. I think you...

    Pretty close to running into you.
    I think you hold the World's Fastest Speed Record for a LiPo battery.

    Sent from Mars Curiosity.
  9. Replies
    26
    Views
    388

    http://www.amainhobbies.com/product_info.php/cPath...

    http://www.amainhobbies.com/product_info.php/cPath/1_25_1466_363/products_id/91654/n/Traxxas-Torque-Control-Upgrade-Kit


    Sent from Mars Curiosity.
  10. Replies
    26
    Views
    388

    Go with the 3.3. More than enough power for...

    Go with the 3.3. More than enough power for anyone just getting into nitro RC.
    I upgraded my Classic T-maxx with the 3.3. Do the Slipper upgrade while you're at it. The rest of the drive train...
  11. Replies
    22
    Views
    425

    Spray contact cleaner where the brushes make...

    Spray contact cleaner where the brushes make contact with the stator. Over time dirt and debris build up.

    Sent from Mars Curiosity.
  12. Replies
    8
    Views
    602

    AVID Traxxas Slash 4x4 Bearing Kit...

    AVID Traxxas Slash 4x4 Bearing Kit
    Maintenance is the key for prolonging the life of any bearing.
  13. Replies
    16
    Views
    343

    Use Blue Medium Loctite. Just enough to lightly...

    Use Blue Medium Loctite. Just enough to lightly cover the threads.

    Sent from Mars Curiosity.
  14. Replies
    7
    Views
    351

    Remove the glow plug. With the glow wire...

    Remove the glow plug. With the glow wire attached. Ground the glow plug to the head. Give it a shot. If the glow plug doesn't glow. You either have a burned out Wand, or the plug is shot....
  15. Replies
    9
    Views
    412

    STRC For the win! :thumbup: Sent from Mars...

    STRC For the win! :thumbup:

    Sent from Mars Curiosity.
  16. Replies
    9
    Views
    813

    SpamBots are getting quite crafty these days. I'm...

    SpamBots are getting quite crafty these days. I'm having to delete spambot entries on my site on a regular basis lately.

    Sent from Mars Curiosity.
  17. Replies
    9
    Views
    419

    Depending on the ambient temps. Nitro in cold...

    Depending on the ambient temps. Nitro in cold weather my require a hotter plug. I don't use the Glow Plug system on the EZ-Start either. I use a sepperate Glow Plug igniter. When the motor does...
  18. Replies
    6
    Views
    431

    Upgrade the slipper clutch while you have the...

    Upgrade the slipper clutch while you have the trans out. The kit is around $25 comes with new input shaft, clutch and pads. If you decide to upgrade to the 3.3 motor, you will be good to go....
  19. Replies
    5
    Views
    158

    Good Job... :thumbup: Just for reference..

    Good Job... :thumbup:
    Just for reference..
  20. Replies
    5
    Views
    158

    Check and see if the ESC to RX plug is in...

    Check and see if the ESC to RX plug is in backwards.
  21. Thread: Snow Pics

    by BAD RC
    Replies
    69
    Views
    3,353

    You can send the excess snow to SoCal. .. Its...

    You can send the excess snow to SoCal. .. Its been T-Shirt and shorts weather here. Ho Ho Ho!

    Sent from Mars Curiosity.
  22. Replies
    9
    Views
    693

    Your local Hazmat Waste Facility will take it. ...

    Your local Hazmat Waste Facility will take it.

    Local Hazardous Waste Collection Facility
    If you reside in El Cerrito, Hercules, Pinole, Richmond, San Pablo and the unincorporated West County...
  23. Replies
    61
    Views
    2,718

    Lets see those videos :thumbup: Sent from Mars...

    Lets see those videos :thumbup:

    Sent from Mars Curiosity.
  24. Thread: Slash Ultimate

    by BAD RC
    Replies
    11
    Views
    538

    I agree, it should have been covered under...

    I agree, it should have been covered under warrenty. Contact Traxxas directly.
    Sent from Mars Curiosity.
  25. I would get the hand held temp gun for just a few...

    I would get the hand held temp gun for just a few more dollars. You can pick one up cheap on eBay, or Harbor Freight. This way you can jump from Nitro to Electric temp measurement.

    Sent from Mars...
Results 1 to 25 of 343
Page 1 of 14 1 2 3 4