Type: Posts; User: Mikey76
Putting new Mamba power up in my Maxx and wondering the best gearing.
It is mostly used for bashing jumping and racing around with a Jato and N-Revo.
It has proline's on it if that matters
What we did this weekend. The last jump slammed my motor forward and caused my spur gear to break
Cool will look into those. Was really just curious if it would fit.
Will the HPI 5.9 fit in the Revo?
ty for getting back so quick
I got my tranny shift point way out of whack and I can't seem to get it back into place.
Can someone tell me where the stock setting is for the tranny from like the set screw bottomed...
I used the trx steel cvds with rpm arms and the extended cups and if I landed wrong or cart wheeled on jumps my cvds would pop loose. I now use the stock rear shafts and the steel front.
Just my 2...
Ok I am wanting more power and all I have read says the red dot is a good motor for that.
I also have read that 17/36 is good gearing.
Well I will be running proline trenchers with proline rims,...
Thats my main issue right now is I am running hot and doesn't seem to have the power it did before i put on the trenchers
I jus recently put trenchers on my revo and i am wondering if I should change the gearing
I was wondering if the is an upgraded clutch for the revo that I can still use the telemetry with?
I am going to be replacing the stock motor with a red dot and want to keep the speed readings....
What is the offset on the standard traxxas wheel? I want the same stance as now just different rim choice's besides the stock rims.
my new paint job
you should be about to return the GH bulks
Hey chicken where would i get those
Does any one else have an issue with the traxxas steel drive shaft's coming out of the yolks near the diff?
Seems when I roll it or land on the rear bumper, the drive shaft's pop out of there yolks.
Got another question, Does any one think that http://buy.traxxas.com/advanced_search_result.php?partnum=3997X would hold the DeWalt motor? I would like to use it so I have a dust cover.
Check this out - http://www.kershawdesigns.com/Products-E-maxx.htm. I have there Single DeWalt for my new e-maxx and I am tickled pink
Ok i did the upgrade and now have the deWalt and I am very pleased that I did it. My question is, I have a Integy dual motor fan with heat sink on the the deWalt. Does anyone know of a way to keep it...
Yes meant 7000 mah, lol. I hope he will answer this or I might just send him a PM.
ok after reading around I am going with SAVSC1256TG but I've been seeing people say something about a bec while using one.
I am going to be running stock esc and 2-2s 700mah lipo's.
I am wondering for bashing if The single servo set up is a good idea and what would be the best servo to go to?
I have 3 open channels on the receiver just no switch to control the open channels