Search:

Type: Posts; User: Sandho

Page 1 of 2 1 2

Search: Search took 0.01 seconds.

  1. Thread: Bad Caps

    by Sandho
    Replies
    5
    Views
    381

    I know this is an old topic but here is the...

    I know this is an old topic but here is the picture of the aftermath when I tried HotRacing's shock caps.

    Blown Diaphragm
    http://www.commspeed.net/sandho/blownshock.jpg

    Snapped Shock Shaft...
  2. Thread: mambo wheels

    by Sandho
    Replies
    6
    Views
    366

    I prefer the 40 Series Cheyenne 23's myself...

    I prefer the 40 Series Cheyenne 23's myself :cool:

    www.prolineracing.com

    http://www.prolineracing.com/proline/wheels/2679/Cheyenne1.jpg
  3. Replies
    10
    Views
    395

    Check your rocker posts. A bent one will cause...

    Check your rocker posts. A bent one will cause them to rub as well.
  4. Replies
    4
    Views
    245

    Try adjusting the tranny also. I've botched...

    Try adjusting the tranny also.

    I've botched 10'-15' of air a few times ending with the same results as well as a shattered engine mount twice and still haven't bent my chassis. :p
  5. Thread: Part ###

    by Sandho
    Replies
    8
    Views
    365

    That sounds like the washers that come with...

    That sounds like the washers that come with Pro-Line's 23mm hex adaptors.

    As far as I know a stock Revo doesn't have them.

    Hit a hardware store.
  6. Replies
    11
    Views
    607

    I've broken darn near every piece on a Revo...

    I've broken darn near every piece on a Revo already and I've come to the conclusion that the suspension has an engineering flaw in the area of travel.

    The stock shock ends get torn out (as if you...
  7. Replies
    13
    Views
    365

    I here ya, I have 1 TRX engine that has never had...

    I here ya, I have 1 TRX engine that has never had fuel in it as well as brand new tires/wheels and a brand new tranny that I'll put in/on the truck if I get rid of it.

    I have 3 Revo's and I've...
  8. Replies
    13
    Views
    365

    You willing to trade that Jato for a used Revo?

    You willing to trade that Jato for a used Revo?
  9. Replies
    9
    Views
    631

    I just took the roll bar off altogether. It fits...

    I just took the roll bar off altogether. It fits better now but it's still not great :rolleyes:

    I was hoping that body would look closer to my '05 TRX450R than it actually does cause I wanted to...
  10. Thread: wheel drive?

    by Sandho
    Replies
    15
    Views
    386

    For 2wd in the rear and still have brakes. ...

    For 2wd in the rear and still have brakes.

    Just separate the front/center driveline at the U-joint closest to the brake then just install the yoke that pins through the brake disk.
  11. Thread: 2wd Revo

    by Sandho
    Replies
    24
    Views
    1,231

    Yes .. those are Mulchers on the front with the...

    Yes .. those are Mulchers on the front with the outside knobs shaved for more of a RazorBack look. I'm still looking for some true RazorBacks that will fit the Maxx wheels.

    Thanks for the...
  12. Replies
    4
    Views
    310

    Here's a good link too ...

    Here's a good link too

    http://www.misbehavin-rc.com/pit-lane/air-filter/nrevo-air-filter.asp
  13. Replies
    2
    Views
    149

    Many links with some very good info ;) ...

    Many links with some very good info ;)

    http://www.misbehavin-rc.com/links/links-painting.asp

    My personal favorits........
    http://www.rctech.net/articles/painting_hauntedmyst.shtml
    ...
  14. Thread: 2wd Revo

    by Sandho
    Replies
    24
    Views
    1,231

    Here's my 2wd Revo. Built this one for when I go...

    Here's my 2wd Revo. Built this one for when I go to the sand dunes. :D

    http://www.commspeed.net/sandho/DuneRevo17.JPG
  15. Thread: Bad Caps

    by Sandho
    Replies
    5
    Views
    381

    You need to use the stock hollow balls then put...

    You need to use the stock hollow balls then put the O-rings on the lip on the hollow balls (one on each side) to hold them into place plus it helps take up any slop.

    BTW ... I bought those same...
  16. Replies
    11
    Views
    323

    Grey plug from the OptiDrive into THR Green plug...

    Grey plug from the OptiDrive into THR
    Green plug into AUX
    Shift and throttle servos go to the OptiDrive
    That should work.

    I'm running forward only so I haven't try it with the OptiDrive.
    ...
  17. Replies
    11
    Views
    323

    Bat/Tel = Main battery power with the ground wire...

    Bat/Tel = Main battery power with the ground wire towards the outside of the receiver.

    STR = steering and again the ground wire goes toward the outside of the receiver.

    THR = throttle, ground...
  18. Replies
    9
    Views
    503

    Check your shock ends to see if they are tearing...

    Check your shock ends to see if they are tearing out. Slop in the suspension is usually the first sign.
  19. Thread: Hummer Body

    by Sandho
    Replies
    13
    Views
    424

    YEP ... it sure will. It's a T-Maxx body so the...

    YEP ... it sure will. It's a T-Maxx body so the little indents for the post holes will be in a different spot than where you'll need em but it will still fit. :cool:
  20. Thread: E-Clip on 2.5r

    by Sandho
    Replies
    9
    Views
    431

    Put that pizza delivery refrigerator magnet to...

    Put that pizza delivery refrigerator magnet to use! ............ :D

    Lay it down right under the clutch bell as you pop the E-clip off with a small flat head screwdriver.

    Guaranteed way to...
  21. Thread: Revo setup ?'s

    by Sandho
    Replies
    11
    Views
    468

    After spending many hours at the bench replacing...

    After spending many hours at the bench replacing broken parts I found it best to run ............

    P-1 rockers ....... NOT P-2's, P-3's or LT's, I broke too many shock shafts & ends with all of...
  22. Replies
    13
    Views
    644

    Here's my latest one........ all the rest I build...

    Here's my latest one........ all the rest I build will be the same as this one :cool:

    Made entirely of steel so it sits very secure on most any surface. Vinyl covered base will not slide or even...
  23. Replies
    27
    Views
    830

    Myself and 2 friends went to a local skate park...

    Myself and 2 friends went to a local skate park last week for some SERIOUS bashing ... they both have RPM arms and I'm still stock on one of my Revo's (RPM arms are on my 2wd Revo) We bashed pretty...
  24. Replies
    13
    Views
    644

    I build my own :D This is the first one I...

    I build my own :D

    This is the first one I built and have since built 4 more.
    They rotate & lock and hold the car very secure.
    I'll post pix of the latest one in the morning. It turned out...
  25. Thread: Revo Gallery

    by Sandho
    Replies
    1,529
    Views
    940,956

    Sticky: 2wd Dune Revo GMC Sierra LP body O.S. 18TM...

    2wd Dune Revo
    GMC Sierra LP body
    O.S. 18TM pullstart engine (installed after photos)
    MotorSaver filter
    RPM arms
    RPM Titan wheels
    Maxx Paddles & shaved Maxx Mulchers
    Single Servo Steering...
Results 1 to 25 of 26
Page 1 of 2 1 2