Type: Posts; User: scott_sms
I just sealed mines.There was already a small stone inside the shaft, thankfully it doesnt need replaced yet. Good design by traxxas if they are trying to sell spare parts :L Thanks for the thread...
If your willing to open it up, you could check to see if any teeth are chipped or if anything is lose and not making a proper connection.
When i said alloy i ment the wheel part. I got the "1/10 RC Car 5 Spoke Wheel Sports 26mm - Black" Maybe i should i waited longer when freezing them. Would be helpful to see a video of someone...
I froze the alloy for about 2 hours and used boiling water also. They did go on easier but I found i could never get the full tire round the alloy always only partly on.
I had bother trying to mount the cheap R2 replica t-drift wheels. Even with freezing the alloy and heating up the tire, i wish there was an easier way to mount them. Pre-mounted much easier way imo.
Nice job. Wish traxxas could get the licence for more real car body's for 1/16th model. One of the main reasons il be getting a 1:10 scale next rc car I buy.
I didn't like the one way diff much. Car went faster in reverse lol
Cool, glad you got it sorted
same. Try turning low voltage detection off, Shows you how to do it in the manual.
Yeah i managed to lock it. You lock the diff by disassembling the rear end then inserting lockers into the diff. Traxxas part number for the lockers is 7381. Yeah drifts much better. Most people with...
I'd buy this!!
Locked the rear diff then tested the car out, already i could see a massive improvement as i was doing almost perfect drift circles and could do some better tricks with practice. Installed the one...
Thanks, couldnt see them as they were covered in dirty or something.
I was trying to lock my rear diff today, took most of my ken block apart and got stuck at this stage...
I can't prise apart the two plastic...
Well i got some parts for my ken block, looking to make it drift a bit better so went ahead and bought some parts.
Center one way
Some spares after...
Why don't you like the 2c lipo's? I run the stock bats in parallel and it seems alright but was planning upgrading to traxxas 2c lipo's part number 2820...
Just a quick question to anyone who has tried, Do the rally, mustang, kyle busch and limited edition 1969 Camaro shells all fit on the ken block without modification ?
Thanks in advance
Do you have 2 servos ? Whats the advantage of that?
Is it best to get a fan/ heatsink when i start using a lipo? I have use two NiMh's in parallel and iv noticed my motor gets really warm.
Would you take £150 shipped to united kingdom?
What's the part number for the one way centre diff ?
How much have you spent on you kb bryan! Got any videos of your car drifting ?
Where did battery come from lol? The shell is £50 in uk brand new painted.
Yeah iv been wanting to place an order with modelsport but most items are "in order with supplier"
Can get these from buy.traxxas.com from america. 3-4 weeks till available in uk