Any picture's of the RX8?
Type: Posts; User: Sir Slide Alot
Any picture's of the RX8?
Number's 1515 means 1.5" stator diameter and 1.5" stator lenght.
no MM's in them used. nor magnet measurements.
Where does that picture come from?
Feigao does have a stator in their design, but it is made different the the usaul slotted design.
It is basicly just washers againt each other and winding is inside them.
Does your shift servo move far enough?
Do you shift like you are suppose to do?
If you use a single 775 from Mabuchi (Bane-Bots, Graupner,...) it fit's right on the standard motor-mount, might get the single plate and single cover tough for good looks.
The Titan 775 from the...
That's what i needed to hear. Thanks George.:)
I got a E-REVO on order and i would like to know if a Revo 2.5 or 3.3 front half-shaft is the same lenght as in the E to use a RD Racing Quick-Turn( one-way axle)?
He has sets for the...
Make holes in the tire, way easier and water can get out. 3mm or 4mm should do.
Quite a bit of them broke, yes.
they are lookin for the solution.
Plenty others out there, Kontronik and Quark being 2 of the best out there they really deserve some more attention.
Tekno RC Neu has a flat spot shaft, bolted endbell, bigger bearings, hand-wound and best of all; BLEU Anodized
If you use the reinforcementplate that come's with the newer E-MAXX/E-REVO diffset the diff should lock more under braking then onpower.
This would give you good brakes without disc brakes, yet...
A ex-boat motor is one thing i'd never buy personally.
Boats are really hard on electronics.
And your best bet for good info (possible pricing) on rebuilding a 15 series Neu is to mail Steve...
Heat it with a solder iron, if it doesnt loosen at 300°C then i dont know.:fear:
Old MAXX wheels with pro-line badlands.
Stumblin, i wish you the best of luck with the Monster Mamba.
Hyperion use Enerland cells as Flightpower does, and the 5350 is very lazy.
It only puts out 15c or so, wich is too low for cars and truck at that mah rating.
look in the Hyperion VX and VZ...
I ran a original HV system for around 10 minutes on the recommended ratio's, after that the motor had a burned true wire in the windings wich made it ready for the trash can.
My last Novak, a 21.5...
I think you would not be able to have a nice fitting body as this will add 30mm chassis width.
Maybe we need a chassis that lets the packs go deeper in the center.
With the standard setup you use 2 channel's.
CH1 for steering, CH2 throttle.
The stock RX has 2 CH1 outputs where both steering servo or plugged into.
If you can mix the auxilary channel on...
No a E-Revo no, it has outboards shocks.
Nice of them to work with plugs on the ESC.