Search:

Type: Posts; User: Psychotoad

Search: Search took 0.01 seconds.

  1. Replies
    19
    Views
    1,564

    It looks like the specs have been updated on...

    It looks like the specs have been updated on Traxxas's website. Both the picture and spec list are consistent and showing that it is 8.9 inch.
  2. Replies
    33
    Views
    975

    How well do the dirt hawgs handle grass? I'm...

    How well do the dirt hawgs handle grass? I'm torn between the dirt hawgs and the badlands since I mostly bash in grass and some dirt, with running on road once in a great while.
  3. Replies
    16
    Views
    1,112

    Any idea if this works with the traxxas wheelie...

    Any idea if this works with the traxxas wheelie bar? Or any other good solutions with this gearbox to help protect the motor?
  4. I have those exact batteries for my xl-5 and...

    I have those exact batteries for my xl-5 and probably do get around 45 minutes on each pack. I have never had any problems with motor temp. I'm never running mine full throttle for the entire time...
  5. Replies
    14
    Views
    693

    Thanks for the replies everyone. I'm still trying...

    Thanks for the replies everyone. I'm still trying to figure out what fits the look I'm going for.

    It was mentioned that aluminum wouldn't be good because it would tend to bend and eventually...
  6. Replies
    14
    Views
    693

    Front bumper

    I would like to get a front bumper for my rustler to help protect it for general bashing use, so I was hoping to get some suggestions. It seems like a lot of people like the RPM bumper, but I don't...
  7. Replies
    0
    Views
    501

    michael76 = good seller

    I bought a servo from michael76 and the transaction went well.
  8. Replies
    10
    Views
    566

    It sounds like you have a good idea as to what...

    It sounds like you have a good idea as to what you need. You won't go wrong with a RPM front bumper. A wheelie bar isn't a bad idea either, however it will be more to protect the motor from damage in...
  9. Replies
    12
    Views
    335

    Chad, for the XL-5, are you using the original tx...

    Chad, for the XL-5, are you using the original tx and rx? I ask because I noticed this exact behavior on my XL-5 just today. I ended up figuring out that my problem was because I had upgraded to the...
  10. Replies
    21
    Views
    1,329

    Since you mentioned heat, do the Checkpoint...

    Since you mentioned heat, do the Checkpoint motors run quite a bit cooler than the Titan? I am just a basher (mostly grass with some dirt) so I know that heat can be a very big problem. Especially...
  11. Replies
    21
    Views
    1,329

    How does that Team Checkpoint motor you mentioned...

    How does that Team Checkpoint motor you mentioned in your previous post compare to the Titan? Does it have more torque, more speed, or both at near stock gearing?

    Also, could you send me the link...
  12. Replies
    21
    Views
    1,329

    Brushed motor replacement

    I have a basically stock XL-5 Rustler (waterproof LVC model), and am looking into getting a replacement motor. As of right now, the Titan is working well, but I knew very little about maintaining the...
Results 1 to 12 of 14