Type: Posts; User: Pangit1
A T-Maxx tank will fit, all you have to do is cut out some of the reciver box "relocate the reciver to the middle batt tray." and wala you have a 125 cc tank
you could also add a heavier Diff oil to help prevent the engine from unloading on 1 tire causing it to spin
boil them for 5 to 10 min or put them in the oven at about 250-275 for same time. the heat will losen the glue.
You have to remember that JATO75 is useing a modded 3.3 w/ a duel chamber resonator pipe and a lightened chassis, so the results that we get will not be the same as his unless you set up like his. To...
also he keeps saying that his HSN is tight....if its tightened all the way, then it would be closed and not allow fuel into the engine. Make sure that the HSN is loose 4 turns from tight.
You might want to have em move that section of fence that is on the track, that could really effect your lap times....lol JK Good luck on Sunday
I just had the same exact thing happen to me, Its the glow plug, change it. It is not completely burnt out but does not have the ability to stay hot enough to run the engine unless you have the E-Z...
only in the rear batt compartment, they wont fint in the middle compartment. they make a 5 cell flat pack that will fit in either. Check out the accessories for the jato on traxxas's home page
to help keep running when its on it's lid is the only reason I could think of
so when is the "How to" and the parts list comming out?
then it will depend on how you have it tuned and how tight your slipper is, its going to very from car to car, but I think mine shifts between 35 and 45 don't know exactly. Something new for me to...
the speed it shifts at is determined by where you have you shift point set to... in other words the speeds will vary..
This place might have some
could have a bad OW bearing
I know Nola just thought I'd give ya a hard time :p
Hey Nola 2/4 = 1/2 lol,
And Steve your not going to get the best out of your car unless you learn how to tune it yourself, the tune will change nearly daily, minor changes primarily to the HSN to...
Man thats about 20 to 25 feet!......What broke?? LOL
this has happend to me twice.. The servo is bad.. If you are going to replace it you should up grade
How is it performing if it is sluggish try leaning it up a bit. this should get you going faster and will raise your temps. Just besure not to excede around 260-270. Also ensure you keep it blowing...
front or back tower? if the back try putting on the wing kit thst New Era offers. this will take the impact and help prevent breaking the tower.
The Jato comes set up for a 5 cell rechargable pack, it even has a power lead that is in the receiver compartment that you need to pull out from the bottom of the receiver box and put into the slot...
so if I put that pipe on my 3.3 it should go 100+ right???? :wacko: :D
I thought the same thing so I checked around and it looks like standard wording that everyone posts with this engine. I think what they mean by "new" is that the are newly redesigned
I looked at the Hi-hobby web site and they were on there for 249.99, thats about a 70$ diff before shipping, thats about the same price that I saw anywhere else for the same engine "249" so I'm...
and then use an exacto knife to finish getting them off the rim