Type: Posts; User: e-revoPCB
Is there one on the clutch i need to put new shoes and spring in and i was going to de glaze the bell but i want to look at an exploded view i dont see one??????
SICK!!!!!!! but wow you must bash hard with all those broken
is this any good For the money or should i just buy a buku...
cool thanks for the info
does it matter which engine mount bolt you put the yellow ground on
and it did
i have all the screws off and yet it still wont come off any suggestions
will the 1/10 e revo wing fit?? or atleast the mount
by closed meaning no gap in the carb then 4 turns clockwise? and the lsn even with button....... and that is were i should start tuning at???
a new revo bought it used so its new to me yay.....well guy says he ran it on 20 percent i am going to use 30 how would i reset carb settings to factory so i can tune my 3.3 to 30 percent
so just loosen then if i have to pull spur gotcha.....check the spring what will it look like if bad ...
stocker........ is the only way to look at the clutch is to pull the motor ????
i took line off looked over put back on and worked fine idk maybe it just needed tlc
if my clutch was going out or was out would it keep it from ideling it will idle with the wheels off the ground but when i put it on the ground it dies
it bolts right were the stock one goes
what is a more power drop in for the jato any out there
and it gets fuel for a sec fires then dies because of lack of fuel
it will slightly pull it when i prime it
I wish i Would have!!!!!!!!!!!!!!!!!!!!
sweet thanks they make one just for the revo
I would have to remove hat to fully see the clutch bell ..but the part that is visable does look shiny blackish ....this means i need a new clutch clutchbell ???
lipo But i would go 2s because i run a 3s and have a truck with a strippped diff
I dont understand Maybe a setting with the idle set screw idk im looking for suggestions
i wanted to mount a wing on my revo thats on its way how will i go about so and which wings are the best fit??
My nitro 4 tec seems to not be getting fuel i checked the lines and they are fine ..when trying to fire the fuel doesnt flow threw the lines but can pull line from carb and pull fuel up with my mouth...