Type: Posts; User: Coletrain
Installed a buku clutch
Luckly enough I didn't bend the chassis. Just broke the front lower a-arm, rear upper a-arm, front bulkhead, front driveshaft and bent my wheel a bit. It's already back up and running
Hit a soccer goal post at WOT
Is there much difference between the stock chassis and the platinum chassis?
I just bent my chassis pretty bad and want to put a stronger one in. Is the vantage carbon fiber chassis a good buy?
The servos are waterproof but with a nitro engine, water in the intake will cause damage
Because its not traxxas equipment you should contact the manufacturer
Well I glued the tires long before I read about taping tires. How do I get the tires off now??
What would be best for a 3.3 with big joes, a close or wide ratio setup?
What would you do to your revo if you had unlimited funds/time?
How much does one of these cost to make??
A 1'x2'x3/16" piece of 6061 aluminum(air craft grade) is roughly $50 and you can cut to make the cage with equipment at your welding school. That should be a big enough piece to make any rollcage
Aircraft grade aluminum will do the best for the weight
Should I be replacing the nut every time I take it apart?
Great idea!! I'll do it next time I have the truck apart. Thanks
Those are the pads that It's had all along and it has happened twice
I tightened the slipper to the point where it puts indents in my finger when turning it. Again yesterday I went out and lost another pad. Does this mean I overtightened it? And is there a more...
Buy 1/4" shrink wrap tubing and cut about a 1 1/2" piece of the fuel line. Cut down the side of the fuel line and wrap it around the blue wire. Put the shrink tubing over that and heat. Add another...
Is there a cage out there that leaves easy access for maintenance?
I was wondering if any of you have tried the rc solutions roll cage for the revo 3.3, and can you still access the truck easily for maintenance? I want a cage but want to be sure it's worth the $150...