Type: Posts; User: binaryterror
I use the gigantic Mugen Fuel Filter/Chamber.
I love the Traxxas fuel tube it has a thick wall and holds on tight. Better to be safe than sorry. I remove mine after every race and clean them and the truck, so in my case removing and re-attaching...
I use the RD Logics one, why because it lines up better to my truck. The RD Racing one needs a bit of tweaking at times.
Also 2 screws to get into the Logics unit, like 18-22 for the Racing one.
The only downside might be torque, but that technology might make up some torque that is uncommon to the .12 size engines.
The obvious and cheapest answers seem to be over looked.
#1 Lower and soften the rear suspension, make it squat and go.
#2 Loosen the slipper clutch.
#3 Re gear to a larger CB.
Most likely you cracked 1 tooth off the ring gear. I did that once long ago when my slipper was a bit too tight. It would run ok, then the broke tooth or the heavens were in alignment and boom it'd...
Jconcepts is working on a longer version due out shortly.
Since this is a drop in you should be looking here: http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXMWJ9&P=7
Number of Teeth: 37 Ring & 13 Pinion
My first one took 45 minutes...
Now i can do them in about 10 minutes. Thats why I love Traxxas, sure its different and maybe complicated, but do it once and you are a pro.
Resonator is 1 chamber, 1 hollow pipe. 2 Chamber is like the stock one or the Trinity. How they got a 2 chamber as loud as they did is mond boggling.
The Resonator is a 1 chamber I believe. Either way I have run both on my TZ and I will tell you they are not even similar in performance and tune. Give me the Resonator any day! Its way better than...
I have run them, they are great, problem I had was the Ofna 17mm adapters after some racing gained some unwanted slop. They add so much steering and work great on hard pack or clay. I ended up...
Do you guys crank these down? I tighten the pins down til they seat with the hole in the metal shaft, nothing near gorilla tight.
I've had mine for along time as well and not a single issue. I've run the 2.5R, OS18TM, and now the 18TZ.
Once again the reason people bad mouth a product out of stupidity, this guy has never even seen an RD Logics box obviously.
The RD Logics is 100% Machined/Stamped and Bent aluminum with steel...
You broke rules, you acted like a kid, you deserve to be kicked out of the track.You let TOY CAR RACING which is a hobby make you upset? Come on act your age. If you feel better by hurting other...
That one the owner removed the pullstart/ezstart nub and one way to use a non-pullstart backplate.
With that engine no you can not use the EZstart.
You must use a starter box.
Go to towerhobbies.com and search its not that hard.
Yellow top "bad for you" Oven Cleaner.
I've never run the Trinity on any of my trucks. But the stock -> Resonator is amazing in power you get. They same low-mid, but I think it helps everywhere on my OS18TZ. Also the Resonator is no...
Why must everyone knock the RD Logics box, especially when they likely haven't used both.
The RD Logics is not at all a copy...lets see ~18 screws to open the RD Racing, 2 for the RD Logics. The...
Ummm the Center Diff is a race item, racing does not allow reverse. The center diff is not something someone who is not serious in racing will even find helpful.
The 3.3 Does not come with the Center Diff as GASSHEAD mentioned, but the stock front and rear diffs are filled with 30K.
18t Turbo good how to...but man those inner Tranny gears need to be replaced looking that bad. Well worth the few dollars since all you need is Ratio (Wide/STD/Close) and the FOC which comes free in...
Viperman, got a link to the 500K?