Type: Posts; User: Matrix243
Way better then I thought it would be.
Bingo got it. It was either the throttle post spinning it around 180 and remounting or rebinding my receiver which gave me more servo throttle movement.
Thanks for the replies. Only with the servo horn set in mid & far hole that it will get stuck and when it does it pulls back the other direction so no WOT. Ran 10 tanks on inside hole and is all...
I can get 90% throttle with a bit high throttle when warmed up so I'm fine with that.
Sorry man, I tried the carb method and it just seems like its adjusting it a different way than I've been trying.
I also set the linkage at mid...
Excellent ideas and thanks for the reply! Never though of adjusting by rotating the carb while adjusting. Also you mentioned checking the manual and sure enough the linkage and on mid point on the...
Still not able to get it. I tried with the carb perfectly square to the linkage/block and slight angled .
Never occurred to me before but replaced the servo batts and seems to be really close now. Maybe just a sliver of the slide showing at WOT.
Revo - 38mph
Decided to do a little comparo to see where both land.
Highly entertaining but risky. I had to set the throttle linkage so I was getting WOT, but meant my idle will be wild if I didn't hold down...
Re-bled the shocks which did help but still bottoming.
Ram mount arm. Only downside is that it's a little on the heavy side and can't seem to add enough preload and shock wt to prevent bottoming.
Lots of people having problems running the LT rockers but seems to work fine. Reminds me of the watching baja suspension working hard. Going to try it out at the track with the side cam.
Not mine and not brushless but...
Switch is good for convenience when you're testing.
Yep, I always pull the batts.
What? Not sure I'm understanding. I dipped the switch so no dirt can get in.
I have all stock plastic parts and tbone bumpers. Never brake anything.
Just realized that there's a spring inside holding the pressure down and it was full of dirt. Stretched it out a bit to keep the pressure on.
Will have to check this.
I switch gave up after only 3 trips to the track. Looked like the dust has effected the rocker somehow. Might be able to modify and make work yet.
Otherwise, any use this switch from radio shack?...
I'm running stock with tbones and virtually zero problems with track use.
Just testing. Imgur is way better.