Yet another SPS conversion...
This time I will be converting a 7001139-Y000 Artesyn
In case you have missed my other builds to date, here are their links:
[B]Be sure to read the warnings/notes I have posted in the above threads... they apply here as well.[/B]
On a scale of 1-10, 10 being the most difficult; this is a 9... possibly a 10.
You will need to be very skilled with a soldering iron as you will be required to solder on a circuit board in close proximity to parts that should not be soldered in order to fire these server power supplies (SPS's) up.
The tools/parts I used:
60 watt soldering pencil
280 watt soldering gun
>Cut off disc
Label of the SPS
Found out that pins 3 and 4 (marked in red) need to be shorted to power up the supplies.
The 30 solder pots on the left in two lines of 15 are what need to be soldered to tap into the 12dcv.
Soldered these two together on the circuit board as it is nearly impossible to solder inside the socket of these supplies.
Definitely not pretty, but it will get the job done. I tied into all of the available areas to distribute the amperage across as many pins as possible.
Here is the only shot I remembered to get of the AC side... sorry!
But here is a diagram:
This project was for a fellow member of these boards.... he requested that two of these supplies be wired up in series, so this is what I did for him. He will be performing the finishing touches himself... maybe he will post up a follow through!