The Official Traxxas E-Revo Video Gallery. Post your Videos here!
Per member request, we're going to try a video gallery for the E-Revo forum. I expect everyone here to follow the rules below, as well as the general forum rules. [B][I]If foul language, dangerous behavior, or other issues become a problem with the videos here, the thread will be deleted without warning.[/I][/B]
To paraphrase from another forum:
Welcome to the Official Traxxas E-Revo Video Gallery. This is a place where you can post your videos to show off your truck and/or your driving skills. Please read the following guide lines:
[LIST][*]This thread is for videos of your Traxxas E-Revos only. [B]If you have a question for one of the people posting a video, please send them an e-mail or a PM so the thread does not get filled up with people talking. This is a place for videos not people asking what body or tires someone is using.[/B][*]When you post a video, it would be greatly appreciated of you would post a detailed summery of what hop-ups you had on your vehicle at the time the video was taken.[*]Anything off topic will be deleted.[*]Any dead links will be deleted.[/LIST]
Traxxas 5605 E-Revo Video and setup
-5605 E-Revo, traxxas 4 channel reciever, traxxas 2 channel transmitter on 27. 195 Mhz with factory dual digital steering servos.
-4 cell Futaba NR4QB reciever pack for servos and ESC fan
-THS CVD kit for all 4 wheels
-Kyosho 17mm Hex ten spoke race wheels with mounted HPI Agressor tires, 217grams each assembled.
-Front 'green' springs, 60wt oil.
-Rear 'tan' springs, 60 wt oil.
-Castle Creations Mamba Max ESC, runs very cool using 4s Lithuim Polymer Batteries 5000Mah
-Integy ESC fan borrowed from Integy motor heatsink
-7xl 2370 kV Brushless Motor Installed with factory pinion and spur gearing.
-2 traxxas 1522 Heatsinks installed. Motor runs quite hot but reliable and lacks no performance.
-Run times on this setup 22-30 minutes
-Video link: [URL="http://www.mydeo.com/videorequest.asp?XID=40819&CID=216074"]Video Here[/URL]
My 3.3 Brushless Conversion
I did this conversion back in January '07. Mamba Max ESC, Wanderer 9XL can, RC-Monster BEC, RC-Monster motor mount, RC-Monster pinion and heatsink/motor clamp, 14 SubCs (at the time of the vid, 4s lipo now). It's in the middle of a rebuild currently.
Ramping a Jeep Grand Cherokee