Jato 3.3 (55077) Engine Assembly | Traxxas

Gift Cards Cart Wishlist My Account

1633: E-clips/ C-rings

1985: PTFE-coated Washers, 5x8x0.5mm (20) (use with ball bearings)

2550: Screws, 3x8mm countersunk machine (6) (hex drive)

2554: Screws, 3x6mm caphead machine (hex drive) (6)

2584: Head screws, 3x12mm cap-head machine (hex drive) (6) (TRX® 2.5, 2.5R, 3.3)

3155: Cable ties, medium black (6)

3281: Cone, split beveled

4116: Clutch bell, (16-tooth)/5x8x0.5mm fiber washer (2)/ 5mm E-clip (requires #2728 - ball bearings, 5x8x2.5mm (2)

4118: Clutch bell (18-tooth)/5x8x0.5mm fiber washer (2)/ 5mm e-clip (requires 5x10x4mm ball bearings part 4609)

4120: Clutch bell (20-tooth)/5x8x0.5mm fiber washer (2)/ 5mm e-clip (requires 5x11x4mm ball bearings part 4611)

4122: Clutch bell (22-tooth)/5x8x0.5mm fiber washer (2)/ 5mm e-clip (requires 5x11x4mm ball bearings part 4611)

4124: Clutch bell, (24 tooth) / 5x8x0.5mm fiber washer (2)/ 5mm E-clip (requires #4611-ball bearings, 5x11x4mm (2))

4146: Clutch shoes (2)/ spring (N. Rustler®/N.Sport/N.Stampede®)

4146X: Clutch shoes (2)/ spring

4611: Ball bearings (5x11x4mm) (2)

5142: Screws, 3x15mm caphead machine (hex drive) (with split and flat washers) (6)

5213: O-ring, backplate 20x1.4mm (TRX® 2.5, 2.5R)

5223: Ball bearings (7x17x5mm) (1)/ 12x21x5mm (1) (TRX® 2.5 engine bearings)

5224: Rod, connecting (TRX® 2.5, 2.5R, 3.3)

5225: Crankcase, without bearings (TRX® 3.3) (requires #5223 ball bearings)

5228: Head protector, cooling head (1)/3x6mm CCS (5) (TRX® 3.3)

5234: Carburetor body/ fuel inlet plug/ 5x.9mm O-ring (1-each) (TRX® 2.5, 2.5R, 3.3)

5238R: Cooling head, PowerTune (machined aluminum, blue- anodized) (TRX® 3.3), head protector (1), 3x6mm CCS (5)

5239: Bolt, carburetor pinch/ 3mm locknut (TRX® 2.5, 2.5R, 3.3)

5240: End cap, carburetor body/ 6.2x1.2mm O-ring/ (1-each) (TRX® 2.5, 2.5R, 3.3)

5241: Screw, idle speed/ 2x1mm O-ring (1-each) (TRX® 2.5, 2.5R, 3.3)

5242: Dust boot, throttle (2)/ return spring (TRX® 2.5, 2.5R, 3.3)

5243: Throttle arm, carburetor/ 3mm set screw (1-each) (TRX® 2.5, 2.5R, 3.3)

5244: Flywheel nut (TRX® 2.5 and 2.5R)

5250: Needle assembly, high-speed (with fuel fitting)/ 2.5x1.15mm O-ring (2)/ 5.3x7.8x.6mm crush washer (2) (TRX® 2.5, 2.5R, 3.3)

5251: Needle, low-speed/ 2x1mm O-ring (2) (TRX® 2.5, 2.5R, 3.3)

5252: Carburetor, complete (minus air filter assy.) (TRX® 2.5, 2.5R, 3.3 composite slide)

5256: O-ring, header 12.2x1mm (TRX® 2.5)

5260: Air filter housing/ foam insert/ straight base/ angled base/ cable tie (1-each) (TRX® 2.5, 2.5R, 3.3)

5261: Air filter inserts, foam (3) (pre-oiled) (TRX® 2.5)

5265: Air filter housing/ foam insert/ Jato® air filter base (long, straight)/ cable tie (1-each) (TRX® 2.5)

5274: Backplate/ 20x1.4mm O-ring (for engines with starter) (TRX® 2.5, 2.5R, 3.3)

5277: Shaft, starter (TRX® 2.5 & 2.5R)

5288: Crankshaft, IPS (for engines w/starter) (TRX® 3.3)

5290: Piston/Sleeve (Matched Set), Wrist Pin Clips(2) (TRX® 3.3)

5291: Wrist pin (1), Wrist Pin Clips(2) (TRX® 3.3)

5292: Gaskets, cooling head: 0.20, 0.30, 0.40mm (1 each) (0.30mm stock) (TRX® 3.3)

5540: Header, exhaust (Jato®) (tubular aluminum, clear anodized) (TRX® 2.5, 2.5R)

6542: Flywheel with magnet (35mm)

6542X: Flywheel (large, knurled for use with starter boxes)

Jato 3.3 (55077) Engine Assembly