I Have A Problem!!! No Power!!!
I just got my Emaxx yesterday, and I cant pull no wheelies.
I have the basics already covered, What I need to know is what is the voltage out-put to the motors? cause with full charged batteries im only getting about 13.5 volts to each motor.
Also, Im the proportional control on the VX-12, in order for me to increase power to the motors i have to turn the control counterclockwise, Not clockwise.
Is this how it is supposed to be?
thanks for any help.
I'm not sure what basics you covered so I'll go through 'em again anyway...
1) Tighten the slipper clutch
2) Glue the tires
3) Make sure pinion gears are not slipping on motor shafts
4) Make sure both motors are running (motor connectors)
5) Make sure the batteries are peaked. (timed chargers sometimes need more than 15 minutes to charge the batteries)
Does the speed control light green in forward and red in reverse?
What is the voltage of each battery pack? perhaps you have a dead cell in one.
I believe clockwise on the proportional control increases output.