Transmitter Swap with Both steering Servos - R3.3
So I've searched this forum (maybe not with the right key words), and I just could not find an answer on if anyone swapping transmitters, was still using both steering servos?
I was pondering either..
1. ST + Y + ST (dont think this is the case due to servo draw and max output voltage)
I specifically just swapped out the TQ with a Airtronics MT-4
If anyone has any advise or suggestions, I'd appreciate it!
figured it out. If anyone is using an mt4, you can put the second servo on ch3 (aux 1), and make it mirror your steering channel (ch 1).
why dont you use a single steering servo?
Dont want to swap out/upgrade, or run single stock.. transmitter handles it now so i am good, pretty cool actually. MT-4 can do a lot