Results 1 to 4 of 4
  1. #1
    RC poster
    Join Date
    Jul 2013
    Location
    Estevan. Saskatchewan
    Posts
    9

    need help with spur gear.

    Hi there. Just found out that I missed 1 friction pad from slipping clutch and now the spur gear is not going straight. I am not sure if I can drive it like this or I should buy a new one. Here are some pictures so you can see better, please help.

  2. #2
    RC Qualifier
    Join Date
    Jan 2013
    Location
    Gurley, Alabama
    Posts
    766
    No, don't drive it like that. You need to replace the missing slipper pads and that should straighten everything back up.

  3. #3
    RC poster
    Join Date
    Jul 2013
    Location
    Estevan. Saskatchewan
    Posts
    9
    Thanks. I didn't drive it since I found that I am missing this pad. I hope it's not hard to put a new one because I didn't find anything about it in manual.

  4. #4
    RC Racer
    Join Date
    Dec 2012
    Posts
    103
    all you have to do if you have ballpoint metric hex wrench sets you take the motor and the tank off unbolt the spur install the pad and then reassemble in opposite order.(if you have Loctite use it to keep the screws in place because I keep losing screws every where).

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •