Results 1 to 5 of 5

Thread: Bulkhead?

  1. #1
    RC poster
    Join Date
    Mar 2013
    Posts
    2

    Bulkhead?

    i broke my bulkhead and installed a replacement however it was an extremely tight fit and now, before the bulkhead broke i was able to do wheeles no problem however now i have trouble barely getting wheels off the ground. would the bulkhead be the issue in this power problem??

  2. #2
    RC Champion
    Join Date
    Jul 2012
    Location
    Yakima, Washington
    Posts
    1,420
    it sounds like your slipper clutch was loosened, just tighten it back up
    With great brushless comes great responsibility.

  3. #3
    RC Turnbuckle Jr. jimbo74's Avatar
    Join Date
    Feb 2002
    Posts
    4,613
    if nothing else changed, it could be..... you might have some binding

  4. #4
    RC Turnbuckle Jr.
    Join Date
    Mar 2012
    Location
    so cal
    Posts
    9,244
    What was tight about it?
    To adjust the clutch tighten the nut until it stops then back off 3/4 turn and try it again

  5. #5
    RC Qualifier
    Join Date
    Dec 2010
    Location
    recalculating...
    Posts
    581
    I'm going to agree you might have some binding going on in the differential, check the slippe first because it's easy access, but if it's the diff take it all apart and see if you can re-assemble it without binding, I know in the rear end if you use screws that are too long for the toe links they will go through and begin to push against the differential.
    I like turtles.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •