SO know i have an ez peak plus charger and i am wondering a couple of things about charging my 1200Mah 6v flat rx pack.
1. Am i charging this at 1 amp?
2. What amp is safe to discharge this pack?
3. When i go into NiMH cycle mode i set it to discharge/charge 1 time. It starts at discharging but only discharges at .1a which is slower then death. Is there a way to increase this number or is this the only option?
4. What is the voltage the charger should read when its full? When i start charging it it says its at 6.54v which is more the 6v is it iover charged?