Results 1 to 4 of 4
  1. #1
    RC poster
    Join Date
    Mar 2013
    Posts
    5

    Rear A Arm pins???

    I just bought a used slayer pro, I was trying to move the rear A arm pins to the upper location but the pins seem to long? When i look in the bulkhead it looks like the bottom hole is deeper. I don't see anything blocking the hole. Did they come with an extra set that's shorter?

  2. #2
    RC Racer
    Join Date
    Jan 2013
    Location
    Delaware
    Posts
    123
    Used.... ya never know what somebody threw in there.
    check out the exploded view on traxxas products page.
    good luck

  3. #3
    Marshal Double G's Avatar
    Join Date
    May 2008
    Location
    Putting the wet stuff on the hot stuff
    Posts
    9,818
    Nope, they should fit in both locations.
    The Super Derecho

  4. #4
    RC Turnbuckle Jr. humayrayakongkinaon's Avatar
    Join Date
    May 2011
    Location
    Long Beach, California
    Posts
    6,770
    you got to give it a good push, sometimes the arm is not line up with the inner hole, give the arm a little wiggle while pushing it in.
    | Rally GT8 Powered By CC | 360mm XO-1 GT |

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •