Hinge Pins

[skye]

ok i bought these for my Slash anyone else have them and i need to know if you do did you have to buy the little clips for them ..Lunsford Titanium Hinge Pin

http://www.ebay.com/itm/200891859668...84.m1439.l2649

[XRated]

It should say in the full description check the listing where it says "includes" but all hinge pin sets should come w/ hardware to secure them, I went w/ the pro 2 hinge pin set and done some hard bashing and not 1 little bend or ding and honestly I like the lock nuts better then e clips

[billy-bones]

Got me,I hate those clip things,In the pic for the T Maxx pins,it shows you the clips,the others don't,I don't care for pro line,but like XR I by there hardened pl kits. As a rule,ill get three weekends off racing out off a set before there shot.
Plus the lhs carries them for $20.

[DiggerPede]

They do come with the dreaded e-clips. As bad as those slippery suckers are the pins make up for it. I have them on my Slash 4x4.

[kdvanb]

E-clips are easy to get on..
Only when you have needle nose pliers..

[XRated]

I might try strc pin set next, but yea their easy to get on that's what I used was needle nose but their so weak and bend easily, I'd rather just use a lock nut hardened steel set and not have to worry about them possibly backing out

[kdvanb]

Yeah I have bent alot too...

[XRated]

sent you a pm kdvanb

[DiggerPede]

sent you a pm kdvanb

The STRC hardened steel hinge pin set is awesome. I run it on all my other trucks. Beats the heck out of flying Eeeeee's. LOL

[XRated]

yea I'm definitely staying hardened steel lock nuts from now on

[ksb51rl]

http://www.towerhobbies.com/products.../dtxr1107.html

[XRated]

nice, for people w/ e clips that'll make things easier

[DiggerPede]

Duratrax Ultimate E-Clip Tool

There is almost a solution (tool) for every problem. LOL Nice find ksb.

[orca44]

I like that Duratrax E-clip tool.... Thanks for the find.... Need to add to the "to buy list".

I personally use the STRC hinge pin set up and haven't bent or have one come loose yet. They are a bit pricey but you will most likely not loose or bend one.... Notice I didn't say never!!! It's about murphy's law. LOL