Adding Telemetry Sensors To Slash Ultimate #6807
I have a Slash Ultimate - Model #6807 - This is the slash 4X4 with the TQI controller & is "Telemetry Ready".
I'm in the process of putting together the parts list I need for all the telemetry sensors, & have a question...
Do I need both the Telemetry Trigger Magnet Holders with Magnet (slipper) - Part #6538 & the Telemetry Trigger Magnet Holders with Magnet (center differential) - Part #6539 or do I just need one of them to measure RPM & Speed?
This is the page i'm referencing:
If your running the slipper you just need pt # 6538 for slipper and magnet. If switching back and forth between slipper and center diff then you will need both.
I just got thru installing all the sensors on mine I soldered in my on wire for voltage to save a little cabbage. Lol
I bought my slash used and it already had correct telemetry motor mount and I bought one thinking I needed it got a extra now. Not sure if it was put in by previous owner or what but came with older non tqi radio I bought all that stuff later.
Last edited by WHOSNEXT; 02-12-2013 at 10:12 PM.
Tags for this Thread