5451r problems (axles)

[Silverdaddy]

So I upgraded my T-Maxx 2.5 4910 to a brushless 2500kv system and ofcourse snapped an outter axle. I bought the 5451r axles assuming they would fit and unfortunately do not.
I know I can by carriers etc to make them fit but was wondering if anyone had an exact parts list required for rears. Part numbers would be great too if handy but obviously I can find those.

Thanks in advance

[DRifTkiNg303]

5143 turnbuckles
5347 rod ends
5355 hollow balls
5120 12x18 bb
5117 6x12 bb
5378 pivot ball caps/dust boots
2580 3x20 turnbuckle screws
4933 pivot balls/bushings
5334 l & r axle carriers

just happened to have a parts explosion in front of me lol. should be it if already have the arms. i didnt buy the hollow balls for the turnbuckle where it connects to axle carrier. just used a spacer to take up slack from smaller hollow ball. hope this helps.

[Silverdaddy]

DRifTkiNg303,

You are the man, THANK YOU very much

[DRifTkiNg303]

yeah no prob

[Wildman4910]

Ebay is your friend here.

Carriers $16.49 shipped
http://www.ebay.com/itm/Traxxas-T-Ma...item4d09c441ab
Turnbuckles & servo saver $17.50
http://www.ebay.com/itm/Traxxas-T-Ma...item4d0b7a6c96

From another ebay'er
Carriers $20
http://www.ebay.com/itm/Traxxas-4907...item5899a650c3
Turnbuckles $7
http://www.ebay.com/itm/TRAXXAS-3908...item20cd7c29d5

[EMAXXBRUSHLESS]

You might want to think of getting the 5334R revo carriers instead. They have the steel rings that keep the pillow balls from popping out.