4x4 not working I think?

[rick lalonde]

I just recently put a some RPM parts on my Slash 4x4 and I figured since I had the tools outs and it's the middle of winter that I take the bearings out and clean all of them and get the truck ready for when middler weather shows up. But after I put her all back together i was spinning the rear wheels manually and the front wheels where not spinning and when spinning the front wheels the rear wheels would not spin? And what I don't understand is that everything was working find before i started working on it.

[davyjones'_fleet]

did you hook the driveshaft back up when you put it together? we need some pics, lots of them...

[rick lalonde]

never took the driveshaft off? But when I roll the truck on the floor it feels like the diffs are slipping?

[vladsly]

You might want to look at your Diffs and the Diff cases, I take the bearings off where my diffs hook up to the cvds because it always stops moving if you run through a lot of water because they almost absorb water.

[rick lalonde]

Thanks for all the great advice. I basiclly went back to the basics and all I did was take the front tires off and noticed that the new aluminum hubs I installed where not sitting in the pins properly therfor causing my problem. Installed everything back in it's proper spots and we are back in action.

[vladsly]

Glad to hear everything turned out fine!

[pgpoacher]

my slash does the same thing after i put the integy driveshaft if but the problem was it was about 4mm to long and it was binding my front diff