Results 1 to 6 of 6
  1. #1
    RC poster
    Join Date
    Jan 2013
    Location
    Turkey
    Posts
    13

    Slayer Pro EZ Start Start Up Issue

    I was bashing carefully on a grassy surface 2 days ago it was shutting off as soon as i leave throttle but when engine gets warm this problem gets solved. Anyway after half an hour i end up in a little puddle and air filter got wet. I tried to ez start but it didn't respond. My ez start cables were messed up so i bought new ones installed today. It started but again as soon as i left throttle it stopped. When i pull the throttle it runs and revs normally but dies when i leave it. I checked glow plug several times and it glowed. I tried glow plug igniter and nothing changed. Btw ez start motor works just fine.

    What can be the problem?
    Slayer Pro 4x4 a.k.a. upcoming SnowSlayer

  2. #2
    RC poster
    Join Date
    Aug 2011
    Posts
    11
    Have you taken the engine apart to make sure that water didn't get into the motor?

  3. #3
    RC poster
    Join Date
    Jan 2013
    Location
    Turkey
    Posts
    13
    Yes I opened cylinder head and cleaned the water in engine. With a plenty of WD40.
    Slayer Pro 4x4 a.k.a. upcoming SnowSlayer

  4. #4
    RC Qualifier
    Join Date
    Mar 2012
    Location
    Edmonton, AB Canada
    Posts
    480
    check your idle gap.... check your lsn..
    Last edited by Ckeithnitro; 01-27-2013 at 10:49 AM.

  5. #5
    RC poster
    Join Date
    Jan 2013
    Location
    Turkey
    Posts
    13
    Both them are set as the factory settings.
    Slayer Pro 4x4 a.k.a. upcoming SnowSlayer

  6. #6
    RC Competitor
    Join Date
    Sep 2011
    Location
    Tucson, AZ
    Posts
    69
    It is likely that your engine needs to be tuned. If your settings are still at factory setting and the motor is broken in you are probably out of tune.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •