Accidently charged 2s LiPo on 3s setting. Help needed please.

[phsycophantsy]

I accidently set my charger for 3s whilst charing my 2s LiPo, it now says over voltage whenever I try any charging options balance, discharge, normal etc
I am using an Imax B6AC charger

Would anybody be able to help me out?
Thanks

[Jimmie Neutron]

What is the voltage?
It needs to be lowered immediately... and safely.

[Cameron]

It let you charge a 2s on 3s mode??? did you not have the balance tap connected?

[Jimmie Neutron]

Prime example as to why a "cooker" is not cheaper than a good charge system.

[phsycophantsy]

What is the voltage?
It needs to be lowered immediately... and safely.

Im not to sure, I dont know how to check either
how would I lower the voltage?

It let you charge a 2s on 3s mode??? did you not have the balance tap connected?

Every other time its connected but I dont think it was this time

[Jimmie Neutron]

Check it with a multimeter:



Does your charger have a discharge function?

[phsycophantsy]

Check it with a multimeter:



Does your charger have a discharge function?

No multimeter in the house
Yes it does, if i plug it in it comes up with over voltage

[phsycophantsy]

I ran the battery in my ERBE as it wouldnt run in my Summit or Ken Block, the ESC would go green then flash red and turn off. But now when I put the batteries back in my Summit the ESC is solid green, I will go run the battery a little more and then balance charge it after.