Results 1 to 4 of 4
  1. #1
    RC poster
    Join Date
    Nov 2012
    Posts
    11

    Hooking up telemetry to 2218x

    Ok kinda new to all this stuff I ordered temp, volt sensors and power tap. I have the tqi docking base from my slash. So I plug the volt/temp sensor into my 2218x and the power tap. I get nothing on the dash board. I paired the controller to the truck and it the steering and throttle works. I tried to plug it into ch 3 4 or 5 and nothing. What step did I miss? I also got the mount for temp sensor but not sure how to mount it any got a pick of there's mounted up?

  2. #2
    RC Qualifier
    Join Date
    Aug 2012
    Location
    Toronto
    Posts
    414
    2218x is not telemetry ready I believe
    Does it say TQi on ur reciever?

    There should be a spot(slot) for, volt/temp and rpm
    Last edited by Daddykins; 01-12-2013 at 03:46 PM.

  3. #3
    RC poster
    Join Date
    Nov 2012
    Posts
    11
    Dont see tqi on it well darn it. Well I got all the stuff for my slash I can get it working on that truck till I get another receiver.

  4. #4
    RC Qualifier
    Join Date
    Aug 2012
    Location
    Toronto
    Posts
    414
    You can always switch out the receiver on the slash n mini
    Or use it for ur slash if u got all the necessary parts

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •