Results 1 to 6 of 6

Thread: clutchbell

  1. #1
    RC Competitor
    Join Date
    May 2012
    Location
    Lake Charles, LA
    Posts
    66

    clutchbell

    I am currently running a 15/40 setup. When I changed out my motor and reinstalled clutchbell. I have some play at the end if the crankshaft between clutchbell and retainer clip. Is this normal or should it be tight at the clip? Ivan move it about a 1/16th back and forth. Didn't know if I had missed a piece. Also my ez start sometimes slips while spinning after reinstalling. Never did that before.

  2. #2
    RC Qualifier
    Join Date
    Sep 2006
    Location
    West Virginia
    Posts
    493
    Take your ez start back off and clean the one-way bearing. Clean it real good, re-oil it with some light oil, reinstall. My bells have some play but I dont think its a 1/16th of an inch. Ill look tonight and see.
    One shot.....One kill, no exceptions

  3. #3
    RC Competitor
    Join Date
    Sep 2012
    Posts
    72
    is it possible that you forgot your washer?

  4. #4
    RC Competitor
    Join Date
    May 2012
    Location
    Lake Charles, LA
    Posts
    66
    I'll pull off ezstart and check owb tonight. And i need to pull up exploded view and make sure I'm not missing something. Thought I had it all. Thanks guys!!!

  5. #5
    RC Racer
    Join Date
    Apr 2006
    Posts
    153
    Check for Teflon washer or you might have to use another washer between block bearing and the cone.

  6. #6
    RC Competitor
    Join Date
    May 2012
    Location
    Lake Charles, LA
    Posts
    66
    Ok thanks 67. I got tied up changing driveshaft boots. Gonna pull motor tonight and check cb.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •