+ Reply to Thread
Results 1 to 6 of 6
  1. 01-09-2013 07:26 AM #1
    yellowufo
    yellowufo is offline
    RC Racer
    Join Date
    Oct 2012
    Location
    cincinnati oh
    Posts
    105

    best fix for stripped plastc threads

    Sorry to double post but what method has been found to repair threads that have
    stuck to a removed screw?
    Reply With Quote Reply With Quote
  2. 01-09-2013 12:19 PM #2
    Jimmie Neutron
    Jimmie Neutron is offline
    RC Turnbuckle Jr. Jimmie Neutron's Avatar
    Join Date
    Oct 2009
    Location
    St. Louis, MI
    Posts
    8,140
    Send a message via Yahoo to Jimmie Neutron
    If a larger screw will not work, I usually put a drop of super glue in the hole and thread it in. I also let the RC sit for a while (usually overnight) before I drive it again.

    The best method in this case, however, is prevention.
    Whatever it is I just said... I could be wrong.
    Reply With Quote Reply With Quote
  3. 01-09-2013 01:35 PM #3
    photon_trap
    photon_trap is offline
    RC Racer
    Join Date
    May 2012
    Location
    So Cal
    Posts
    227
    Lightly lube a screw, wipe off ALL excess put some structural epoxy like JB weld in the hole and "thread" the screw in. lube should prevent adhesive from adhearing to the screw making it removable after adhesive sets up. Just an idea.
    Reply With Quote Reply With Quote
  4. 01-09-2013 01:53 PM #4
    yellowufo
    yellowufo is offline
    RC Racer
    Join Date
    Oct 2012
    Location
    cincinnati oh
    Posts
    105
    Jimmy the threads came out when i unscrewed them to install a wheelie bar so in this case your funny aint so......
    Last edited by yellowufo; 01-09-2013 at 02:03 PM.
    Reply With Quote Reply With Quote
  5. 01-09-2013 05:45 PM #5
    robl45
    robl45 is offline
    RC Racer
    Join Date
    Nov 2012
    Posts
    224
    the way you fixed stripped holes in wood is to glue a tooth pick in the hole and break it off, I imagine this would work similarly well. You also could fill the hole with plastic epoxy and then redrill the hole.
    Reply With Quote Reply With Quote
  6. 01-10-2013 05:11 PM #6
    yellowufo
    yellowufo is offline
    RC Racer
    Join Date
    Oct 2012
    Location
    cincinnati oh
    Posts
    105
    Beware of the pre loctite applied screws as they seem to be the problem a thanks to the few for the replies.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules