Results 1 to 3 of 3
  1. #1
    RC Enthusiast
    Join Date
    Feb 2012
    Location
    SW arkansas
    Posts
    33

    Slipper Clutch Problems

    I built my revo several months back and have had the bugs worked out for a while, i put a picco .26 on it and had no problems till now. for some reason the slipper clutch will not grab anymore. started when i went to slayer gears in the trans. i put a brand new slipper setup on it and it lasted almost a full tank of fuel and then it started slipping and won't grab at all. any suggestions?

  2. #2
    RC Competitor
    Join Date
    Oct 2012
    Posts
    90
    why u put slayer gears in it? does that basically lower ur gear ratio??
    revo 3.3 tmaxx 3.3 ofna hyper 7

  3. #3
    Marshal Double G's Avatar
    Join Date
    May 2008
    Location
    Putting the water on the hot stuff
    Posts
    9,702
    The pads may be glazed so you would need to clean them up. You could do the E-Revo slipper upgrade or use the T-Maxx classic brake pad (with the hexagon center) as a slipper clutch pad.
    The Super Derecho

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •