Thread size on the end of the stub axles ?

[Brett74]

Hey guys, out at sea at work, need to know if the threads are M6 or M5 on the axles of my ERBE ?
Anyone care to check and let me know ?
Thanks in advance...

[JustinThyme]

M6

Sent from my Transformer Prime TF201

[Brett74]

Thank goodness, spent two hours making some hex stabilisers thinking they were 6mm threads and then started looking around here and was sure there was some mod with a 5mm thread and some brass inserts...everyone sure, last chance as I don't have a lathe at home...Thanks Justin...

[Brett74]

Perhaps the older E-revos only had 5mm axles ? Can anyone clarify this?

[50togo]

Pretty sure they were 6mm too

[Brett74]

No-one got a spare they can check for me ?

[50togo]

I just pulled up for an old t maxx and e maxx used the same

[Brett74]

Not quite sure what you mean, sorry?

[50togo]

They were both 6 mm

[Brett74]

Sorry if I am being a bit thick here, I know the axles are 6mm but the threads on the end of them are they M6 ?
Thanks for your patience...

[50togo]

I don't remember this but the manual says its a 5mm

[87 GN]

The stub is 5.98 mm & the thread is 4.89 mm.. I use to have that info now can't find it.??

[Brett74]

I actually phoned my wife and got her to dig around and find an axle in my parts box, I didn't know but she knew how to use a Vernier and was quite insulted when I asked her if she did...she came up with the same measurement for the threads which are then M5. Thanks for the help and the confirmation.
I will do a thread when I get home in a week on my mod.

[87 GN]

You have a good woman......