LED flashes red-green; 2080 servo replacement

[sonderm]

Hi,
I have the 7105.
I have had to replace the 2080 servo as mine burned/melted/fried.
After replacing with new servo, the LED on the main unit (ESC?) goes into a flashing red to green to red...mode.
Once in that mode, I can't even use the button to turn off the unit.
What does that flashing mode mean?

Ideas?

Mark

[50togo]

Don't know why nobody has helped by now.
Disconnect the servo and see if it still blinks. If it does the old servo burnt the esc too

[apaulo13]

the ESC may be in lipo mode. If you are using NiMH batteries, the esc sees too much voltage and flashes red/green. Switch back to NiMH mode by holding the set button for 10s. Should beep 3 times and switch modes. Maybe.

[azzy522]

As Apaulo13 said.
check this out from when I was having similar problem.
http://traxxas.com/forums/showthread...flashing..HELP