Results 1 to 2 of 2
  1. #1
    RC poster
    Join Date
    Jan 2013
    Posts
    3

    Stampede VXL - Fast Mode Changes

    New Xmas owner of a Stampede VXL 2x4. The manual states that I can do a "Fast Mode Change" on the VXL-3s by a press and hold of the "set" button until the LED blinks 3 times. I assume this is the set button on the TQi transmitter. When I do this, the LED blinks repeatedly red and will not stop until I let go and press and hold the set button again which turns the LED green. This has no effect on the profile. Am I doing this correctly?

    Thanks

  2. #2
    RC Champion
    Join Date
    Jan 2007
    Location
    Michigan
    Posts
    1,677
    If your talking about the profile modes, These are done by holding the EZ-Set button on the ESC itself.
    Last edited by dave00bear; 01-04-2013 at 06:58 PM.
    My previous sig conflicted with a forum policy.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •