Results 1 to 6 of 6
  1. #1
    RC Qualifier
    Join Date
    Mar 2006
    Location
    S.Wales,uk
    Posts
    733

    Finally finished my little project.

    I kept this quiet for a bit as I didnt really know what path I was taking but here goes.
    My project started life as a run of the mill 3905. I bought it 2nd hand and was bitterly disappointed with various things , such as the performance on NIMH and the plastic chassis which is poor at the best of times....then the project began. You know what its like...you start with a little something and suddenly you have rebuilt it all. Well you could say I rebuilt it all.

    T Maxx 4907 chassis. Modded to accept E Maxx Tranny
    Single motor plate and covers
    Hobbywing WPSC8 and 2350Kv BL motor.
    Traxxas upgrade slipper kit
    Slash waterproof receiver box.
    Single High Torque servo
    Modded servo saver
    Battery trays cut from yet another snapped chassis
    FLM Bulks
    FLM Shock towers
    FLM bulk braces.
    Alu skids cut down
    Modded chassis braces to take brackets for Tranny mount
    BL Diffs
    Lundsford hinge pins
    RPM front arms
    RPM True Track Rears
    Traxxas Red Turnbuckles
    Thunder Tiger MTA4 roll hoop
    Thunder Tiger MTA4 side guards
    Traxxas big bores
    Traxxas Centre shafts

    I think I am done.










    Any comments welcome.
    " TRX3922a doesnt snap " IT SHATTERS !!!

  2. #2
    RC Turnbuckle Jr.
    Join Date
    Mar 2012
    Location
    so cal
    Posts
    9,244
    looks nice! might have to move over to the brushless forum!

  3. #3
    RC Qualifier
    Join Date
    Jan 2009
    Location
    MI
    Posts
    741
    Good Job. I always wondered if the T-Maxx Chassis would make the E-Maxx Stronger, especially the for holding better the bulks. Keep us posted.
    Not enough space here

  4. #4
    RC Turnbuckle Jr. humayrayakongkinaon's Avatar
    Join Date
    May 2011
    Location
    Long Beach, California
    Posts
    6,709
    neatly done....indeed. nothing like converting a nitro into an electric. that for sure is much stronger than the stock e-maxx
    | Rally GT8 Powered By CC | 360mm XO-1 GT |

  5. #5
    RC Qualifier
    Join Date
    Aug 2011
    Location
    delaware
    Posts
    937
    good job the truck turned out real nice

  6. #6
    RC Qualifier
    Join Date
    Mar 2006
    Location
    S.Wales,uk
    Posts
    733
    Thanks for the compliments guys. I still have to sort out the center skids underneath as the tranny sits lower on the T Maxx chassis. Thsi means the stock grey doesnt fit anymore. I have had to space it out 1/4" from the braces to get some protection there. This is why it looks a little chopped up from the bottom. I modded the RPM center from the short chassis I had hanging about and chopped the grey one so they would at least meet. I am looking for a cheap alu one I can bend to fit a bit.
    " TRX3922a doesnt snap " IT SHATTERS !!!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •