Advice on drive shafts

[ozfst]

Has any one ever used these?

http://www.ebay.com/itm/190745759796...84.m1423.l2649

They seem beefier than the chrome metal CVD's. I have these now and one is bent. I was looking into some other drive shafts. I run 6s lipos.

[87 GN]

have not seen those yet, so idk... some of us use the Summit drive shafts...

[Cameron]

^^ do you need 4 long? or does the 2 and 2 work? Been thinking about ebaying a set of them for my ERBE

[ozfst]

Will the summit shafts hold up to 6s?

[humayrayakongkinaon]

the 2 short ones works fine only problem is the dust boots are stretch to its limits but then again them boots dont last long anyway, i run mine without dust boots

[87 GN]

put the shorts in the rear....jmo

[hottrodd1090]

summits work great and if you want just go to your lhs and get 2 long shafts for like 8 bucks is all i did and kept the shorts for spares

[RockchalkJayhawkz]

Those look similar to the lst2 cvds. They might be worth a shot. I did the lst2 mod and couldn't be happier with it. They have help up through some pretty good jumps and cartwheels and haven't bent in the slightest. The mod was super easy to do.