Results 1 to 5 of 5
  1. #1
    RC Racer
    Join Date
    Sep 2012
    Posts
    225

    Icharger206b flashed warnings?

    what should I use for settings for my SPC 8200 Lipos I don't think I'm getting the kind of run time I should.

  2. #2
    RC Turnbuckle Jr. Jimmie Neutron's Avatar
    Join Date
    Oct 2009
    Location
    Alma, MI
    Posts
    12,281
    Capacity cut off should be switched off.
    If you are charging two at a time in parallel, amperage should be at 16.4 for 1C charge rate.
    If you are charging one at a time, amperage should be at 8.2 for a 1C charge rate.

    What kind of run time are you getting?
    What are the conditions you are running in?
    Whatever it is I just said... I could be wrong.

  3. #3
    RC Racer
    Join Date
    Sep 2012
    Posts
    225
    I'm charging one at a time I'm just not good with the charger ,duh! ok, I just looked at my setting and I was charging one at 16.4A ...... I'll change it to 8.2. wow, I was just reading what the paper said about charging. Do you think I did any damage? should it be "ballanced charge" This is what I am thinking I should use.
    Last edited by 04zrx; 10-06-2012 at 01:40 PM.

  4. #4
    RC Turnbuckle Jr. Jimmie Neutron's Avatar
    Join Date
    Oct 2009
    Location
    Alma, MI
    Posts
    12,281
    Since it is a SPC pack, I doubt it.
    I think those can be charged at 2C (or higher) without issues... it should say right on the pack.

    You are balance charging, correct?
    What stage do you have the charger set to start balancing?


    In all honesty, these questions should be directed over to the forum I linked you to previously... the rules state that this forum is for Traxxas items only.
    Whatever it is I just said... I could be wrong.

  5. #5
    RC Racer
    Join Date
    Sep 2012
    Posts
    225
    Jimmy, thanks, I don't want to break any rules thanks for the info.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •