Results 1 to 2 of 2
  1. #1
    RC Racer
    Join Date
    Feb 2013
    Location
    York, PA
    Posts
    112

    Thumbs down TQI not holding steering end points

    So I just got a new 6518 RX and followed the directions to link it to my TQI 2.4GHz tx.

    I power it up only to notice the steering only goes half the distance it normally should.

    So I reset the TQi to the factory defaults and try it again. Same issue.

    I then go into the menu mode and reset the End Points to the factory defaults. Same issue.

    Then I go into the menu mode and go to the Set End Points. Here the steering will turn the full distance. So I save the settings and exit the menu only to find that the steering goes back to only going half the distance that I just set it.

    I'm at a loss here. Anyone?

  2. #2
    RC Racer
    Join Date
    Feb 2013
    Location
    York, PA
    Posts
    112
    nevermind, I figured it out. freakin' steering % (dual rate ) setting in a separate menu

    Why wouldn't the reset return this to factory default.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •