Can anyone help me understand how to wire a servo directly to power (Castle 10A BEC) an pull signal from my receiver (Traxxas 2218X)? For the life of me I an a friend cannot figure it out. We have tried two different castle BECs and 3 different servo brands with no luck. Does te Traxxas rx not support this kind of setup or am I missing somthing?

I am replacing the stock dual 2075 setup with one large high current draw servo and adding rear steer to my Summit powered by the same servo.

This is the diagram I am using

My rear steer.

Any help would be apriciated!


Sent from my iPhone using Tapatalk