Tekin T8 Truggy motors G2, pictures of the back for the HPP brace for the E-revo....
I will need a detailed picture of a Tekin G2 T8 Truggy motor on the E-revo or at least of the back side of the motor seeing the sensored cable to send to HPP Germany for them to fab a new motor brace for that sensored motors!
I am asking because i have an E-revo Roller and want to put a Tekin T8 Truggy motor on it!
Have you tried searching Google image for pictures? I found some but you'll have to see if it's what you need.
Search for "e-revo tekin t8"
You already posted same question days ago....http://traxxas.com/forums/showthread...truggy-motor-s
It won't work with tekin motor..unless you don't use the sensor,,,so there is no point of using the tekin system
Last edited by NFS; 06-05-2014 at 04:23 AM.
I asked HPP from Germany and they said they can do it, but need to have a pic of the back of the tekin g2 motor!
Like i said i am in contact with HPP and they asked me a pic of that tekin t8 g2 motor to see if it's possible for them to make a new brace motor for that!
As for the net... of course i searched first... but never saw that... only with the older red T8 truggy motor!
Originally Posted by NFS
Seems they should purchase a motor to have the physical specs and beable to do a manual fit. Not just look at a pic and say awww that outta fit.
Even unsensored, the tekin is smoother than the castle. But unless you are crawling, both motors are smooth enough for a revo.
Last edited by targetingxmod; 06-05-2014 at 06:05 AM.
I would buy that brace right away. I have truggy gen2 motor too, but don't forget to mention that can is significantly longer on tekin truggy.(mamba is same length as buggy motor according to specs). I had to cut from rear shock mount(part 5317) to fit motor properly as low as possible. I will post some pictures later.
Last edited by Marek_K; 06-05-2014 at 07:55 AM.
T8 Truggy is 77mm Long, castle 1515-2200 is 75.18mm, castle buggy 1512 motor is 68mm Long, not really the same.
Originally Posted by Marek_K
Ok, they said it's possible to made it!
Of course said the lenght and diamater is a little more then the Stock motor but to make them they need to have more customers asking for it...
So for now... all i can do is asking you guy who have Tekin's on E-revos to mail HPP for a motor brace for our Tekin T8 motors!
GO GO MAIL HPP!
Nah...too expensive. I never had any issues stripping a spur, so for me it is not really needed, also there are other ways to make the stock motor mount stronger, just putting a long screw across the motor plate and mount, and tighten it up with a nut, it works really good.
HPP parts are overpriced and pointless.