Aftter all my reading on this subject still not shure. Do i need an external bec to run my hytek hs7955tg servo. or will the built in bec on my monster mamba esc work without damaging it? I notice theres a place on the castle link where you can adjust the bec output ?is this setting for the internal bec? I think it is set for 5.5 but it can be set higher?
Also will it be nessesary to program the servo in any way. It has an overload built in, but is off from factory. seems like you would want to turn it on somehow?
+ Reply to Thread
Results 1 to 4 of 4
Thread: servo question
-
07-31-2012 12:05 PM #1RC Qualifier
- Join Date
- Feb 2012
- Location
- Brookline, NH
- Posts
- 718
servo question
Last edited by EMAXXBRUSHLESS; 07-31-2012 at 12:09 PM.
-
07-31-2012 09:01 PM #2RC Turnbuckle Jr.
- Join Date
- Mar 2010
- Location
- kansas
- Posts
- 6,403
yep it is a Summit but a few diagrams on wiring the BEC
http://traxxas.com/forums/showthread...=1#post5030490Would you go flip my truck back over??
-
07-31-2012 09:36 PM #3
U will prolly be ok without a bec. The monster bec should work just fine.
Merv, Sl4sh, P4de, Embe, Slash
2400/2200/4000kv
-
08-03-2012 02:36 PM #4
The voltage adjustment is for the MMM's internal BEC. You might need an external BEC with a 7955TG. I'd contact Hitec and find out how many amps it uses. If it's over 3 amps get an external BEC.
Reply With Quote
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts