Results 1 to 9 of 9

Threaded View

  1. #1
    RC Champion
    Join Date
    Mar 2010
    Location
    Davenport, Iowa Quad Cities
    Posts
    2,470

    Spur gear meltdown and slipper overheated w pics!






    So lastnight I ran a couple test runs with some friends. I noticed my slash seemed to be not moving but the rotor was turning. So I take off the body and smoke was coming out of the slipper area and you can smell burnt plastic. It was pretty strong. So after we took the rear apar I found my spur gear all melted all over and the slipper plates and pads were insanley hot and warped. It was entertaininf at my expense.
    The gearing was 22/50. Thought my slipper was tightened down. I know the gear ratio is bad. Looks like I may go up in slipper and get a smaller pinion lol. Was thinking about the RR Gen3 slipper but all metal isn't always good. Need to have a weak point to absorb the energy and reduce damage. Just have to figure out what would be ideal gearing for a mamba 2200 for bashing and still be able to outrun my buddy's erbe and savage flux!
    The other issue is should I just switch to mod 1 gearing since I like to run in sand and gravely areas.

    Gotta love rc. So many tough calls to make...
    Last edited by Dknuckles; 06-25-2012 at 12:27 PM.
    Thrash It, Bash it, Break it, No Regrets!!!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •