Results 1 to 2 of 2
  1. #1
    RC poster
    Join Date
    Jan 2011
    Posts
    13

    Pinion gear adjustment maxed out, spur gear eaten up.

    Has anyone else had any problems setting the gear mesh? My pinion gear decided to eat all of the teeth off of my spur gear so I bought a new spur and after installation I went to set my gear mesh and noticed that the slotted adjustment hole doesn't allow the motor to turn far enough to engage the gears so mesh ends up loose. I have the stock 14/68 gearing. Anyone else have an issue?

  2. #2
    RC Champion
    Join Date
    Jul 2007
    Location
    Rc Room
    Posts
    1,509
    Dremel time! Make that slot longer if the motor isn't bottomed out already. Or run a larger pinion or spur.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •