Servo won't turn for brake

[Inflic501]

So I finally got a jato I bought used running, had to replace the engine, but when I push the acceleration finger, ( not sure what else to call it) back for the brake the servo doesn't move back, is it a bad servo?


---
I am here: http://tapatalk.com/map.php?wpq1ou

[Mind_Reader7]

So I finally got a jato I bought used running, had to replace the engine, but when I push the acceleration finger, ( not sure what else to call it) back for the brake the servo doesn't move back, is it a bad servo?


---
I am here: http://tapatalk.com/map.php?wpq1ou

No it's not. You need to take the servo horn off, and place it at a different angle.

[Inflic501]

I took the horn off, and when I pressed it
For gas it moved one way, but when I pushed it for brake it didn't turn that way

[Woodster]

might have a servo with stripped gears i had that issue with a steering servo, it would turn one way but not the other

[reyesjhs765]

I hope you didn't pay much for the Jato. I just bought a Jato 3.3 and Revo 3.3 with traxxas 2.4ghz for 125.00. nitros are going really cheap now

[Inflic501]

Well I actually bought a jato 2.5, already replaced the engine to a 3.3 and a revo 3.3 and replaced some bearings and air filter, and a few other things, paid 400, I have the jato running besides the brake, an still have to do some more tunning in the revo, can't get it to shift, but no more used nitros for me I think


---
I am here: http://tapatalk.com/map.php?kmfcsv

[Jersey Jato]

Try plugging the servo into the steering slot on the receiver and see if it turns both ways.

[Inflic501]

I did, only turn one way, and maybe 1/32 of an inch the other way So I just ordered another, hope that was the fix


---
I am here: http://tapatalk.com/map.php?mj0sj4

[Assassin]

TQi tx? Could just be set up wrong in the adjustments and need to be reset.

[Inflic501]

I have reset the transmitter


---
I am here: http://tapatalk.com/map.php?r0yv0z