Integy Motor Fan/Heatsink

[TrenJen6796]

I know this product says its for a Slash, I just want to make sure since it looks a little big for the velineon system since the wires come out of the top so it loses a little area on the top. It means that it will fit the stock Velineon System correct? Thanks.

(http://www.rcboca.com/integy-motor-h...slash-4x4.html)

[wtrchuck]

No reason it shouldn't, since it just clips on the motor (allows you to slide it back and forth to clear your motor wires).

[traxxasFTW]

ive had it on the vilenion, it fits, dont get the double fan, only the single. I heard the double causes problems.

[MAYOR VXL]

Much cheaper here: http://www.rcplanet.com/Integy_Cooli...tt8534blue.htm

I have the dual fan and Ive had issues with one of the fans - sometimes it works and sometimes it doesnt. Regardless, this fan does a GREAT job getting a Velineon motor to cool down quickly.

[SlashandBurn]

the dual fan works fine as long it is pluged into your reciver. i had my dual fan off to the side but it was blowing hot air on my lipo. i took my motor out and turned the mounting plate 90 degrees so the motor wires are off to the side, the put the fans on. i had mine pointing straight down and it works great no hot air blowing at my lipo, but if you tilt the fans towards your batt. it will pull more air over it and will keep it cooler as well.

[El Sob]

I bought that setup for my truck a couple years ago. I suggest going with a single fan. It over loaded the trucks beck which caused it to freeze on place. You couldn't steer or use the throttle. You couldn't even push the truck, it was locked in place. I highly suggest getting a single fan setup. I had it plugged into the rx box and the esc. Made no difference. Just giving you the opportunity to learn from my experience.

[SlashandBurn]

a glitch buster will fix that i have been running dual fans pluged into the reciver for 4 months with no problem

[ryan.]

I run the dual fans plugged into my receiver, no problems at all.