I run my slash when is raining or a wet area(like wet grass)?
The manual say than my slash is waterproof, is really waterproof or i need to make modifications?
I run my slash when is raining or a wet area(like wet grass)?
The manual say than my slash is waterproof, is really waterproof or i need to make modifications?
Slash 2wd w/ MMC
T-Maxx 3.3#4907
Summit 1/10
You should be fine. What battery are you using ?
NiMH Power Cell Series 3 #2940 with a parallel connector
Slash 2wd w/ MMC
T-Maxx 3.3#4907
Summit 1/10
You should be fine running your slash in water. Just make sure if you do run in water alot to keep an eye on your bearings because the water will dry them out of oil. Everything on the slash is "waterproof" but the trannsmission can let water in over time on the seal in the front bottom of the cassing. Have fun running your slash in the water!
DeWalt 1/8 Summit, Slash XL-5, Slayer Pro 3.3.
Your black screwsheads will rust over time.you can replace em with stainless screw off eBay.
My Black & Blue Rally is faster than your color...
ok thanks for the help![]()
Slash 2wd w/ MMC
T-Maxx 3.3#4907
Summit 1/10
It is completely waterproof, but I would recommend putting a dab of grease on the underside of the little cap on the top of the aterproof reciever box. It helps keep the water out.
Sting like a butterfly and punch like a flea, jack
Make sure after the run you completely dry the car and lube the bearings. I sprayed wd-40 on my screws to prevent rust.
Stampede 4x4
Anza Slash VXL
Rustler VXL
tape over the air holes in the tires if you get water in there it can be a real pain.
Slash 2wd Vxl; Crash and learn