Fuel?

[e-revoPCB]

My nitro 4 tec seems to not be getting fuel i checked the lines and they are fine ..when trying to fire the fuel doesnt flow threw the lines but can pull line from carb and pull fuel up with my mouth hahahaa but yea ...acts like my carb isnt wanting to pull fuel......I checked the pressure line and it isnt kinked or anything ??? its just not getting fuel

[e-revoPCB]

I dont understand Maybe a setting with the idle set screw idk im looking for suggestions

[chadkillzone]

Did you look at if you have a air leak any where? And if you prime it will it pull any fuel threw the lines?

[e-revoPCB]

it will slightly pull it when i prime it

[e-revoPCB]

and it gets fuel for a sec fires then dies because of lack of fuel

[chadkillzone]

I would look and test to see if you have a air leak in the engine somewhere. If you prime and you get fuel and then release your finger from the stinger and you see no fuel flowing, how old is your motor? Sounds like you are not building pressure to supply fuel to the engine.

[e-revoPCB]

i took line off looked over put back on and worked fine idk maybe it just needed tlc

[mike-susieq1]

i would replace fuel lines and clean the carb out the, hsn more likely has something inside blocking something or the fuel line has some build up in there or a slight cut not very visible.