Results 1 to 4 of 4
  1. #1
    RC poster
    Join Date
    Mar 2012
    Posts
    3

    vxl-3s troubleshooting question

    my vxl-3s went up in smoke 3 weeks ago. replaced it but new one wont calibrate. red light blinks once then nothing. when i try to use it forward and reverse has no respose. then when i turn the steering wheel, the front wheels turn a little and the it goes forward and reverse depending on which way i turn the wheel any suggestions? thanks
    Last edited by don kilen; 03-24-2012 at 01:58 PM.

  2. #2
    RC Qualifier
    Join Date
    Nov 2010
    Posts
    397
    Check to make sure the servo and esc are plugged in to the right channels on the rx. It sounds like you have them plugged in to the same channel.

  3. #3
    RC poster
    Join Date
    Mar 2012
    Posts
    3
    that was it. thanks a bunch!

  4. #4
    RC Qualifier
    Join Date
    Nov 2010
    Posts
    397
    Glad I could help

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •