Wireless starter help?
Ok I have the r.o.ss starter and wiring it in . But I m using tqi transmitter from electric summit.and receiver.
I'm use in this because of extra channels. I have a nitro revo 3.3 with opti drive.
But I can't get the controler and receiver bound. Went thro the whole hold set and so forth. Did not work. And I haven't even hooked up Ross yet. Just want to use tqi remote on my nitro.
Is there special programming u have to use to make a electric remote and receiver work for a nitro truck.
The tx and rx don't care if it's controlling electric or nitro. There should be the set-up card in the battery compartment or you could download the instructions straight from the Support tab above.
I've done the binding instruction and also returned remote to stock settings? Any other ideas. Would opti drive need to be programmed at same time. Or could opti drive be messin with everything
Should be able to plug Ross into receiver and use switch on summit remote( either Gera select or locker switch) to turn Ross starter on correct? What is little two point plug for ?
Anybody know these awnsers
Ok so I got transmitter and receiver bond but I can't get opti drive into program mode. Grrrrrr. I use iPod to bind remote