bare with me as i'm still new to this.
i just finished a complete tear down and reassembly.. installed a bunch of RPM items and MIP Xduty CVDs.
i heard a pretty loud whine on my first run so i took the back end off and tightened the slipper all the way (i didnt know what the nut was when i first tore it apart last weekend and loosened it pretty far).
i did a few laps around mine and my neighbors yards.. flipped the truck over.. put it right side up, then drove a few feet before noticing the front wheels werent spinning.. drove about 10 more feet and no power to any wheels.
brought it back to the garage and found i lost the front left 'female' cvd shaft --- must not have tightened the screws enough. (hopefully i can find the thing..)
anyway.. if i hold the truck off the ground and hit the throttle, the three wheels will spin. if i sit the truck down , i see the pinion/spur moving, center shaft spins, but no power to the wheels.
is this because the front left wheel is not hooked to the diff? i took the rear diff out and the gears look fine. it was running great before it flipped over and then 15ft later no power at all.
my thumbs are raw from the standard traxxas wrenches.. ive got to run a couple errands before i can get back in to this. thanks!